Over the course of being on dialysis for several months, I have initiated several tweaks to the process to save time, energy, and increase safety of the system. Today’s blog discusses four of these “system improvements.”
The cap on the end of the “Blue is you” fitting that attaches the Cycler to your catheter line can be rather hard to unscrew from its as delivered position in the cassette package. I would surmise that those with arthritic hands would find it particularly difficult to loosen. I have found that it helps to “break loose” the fitting while it is firmly in place in the stay-safe receptacle. Don’t unscrew it -> just loosen so it’s finger tight, then proceed with your hooking up to the Cycler per stated norms. The square fitting on the end of the connection is 10 mm, so having a 10 mm open end wrench by the Cycler supports this operation. I have one as shown below which I use nightly.
By necessity, the plastic line from the Cycler to my bed travels across the floor in front of the access door to our Master Bedroom. Especially in the dark, this is a potential tripping Hazzard for my wife’s entry and exit from the bedroom. The next two hints address this safety issue.
First of all, the line: From Amazon I purchased a product that is normally used to cover electric cords as a cover for the plastic line. Nightly, as part of the Cycler setup, I run the Cycler attachment line through the bottom slit in the cover, turn it over, and presto, the tripping hazard is alleviated. See picture below.
The second hazard is being able to see the cover etc. in the dark when my wife leaves or enters the bedroom. Again, from Amazon I purchased two LED motion sensor-capable lights that are placed by the door and armoire (pointing toward the bed) that turn on automatically for about 10 seconds with motion, then off. In the dark they provide an abundance of light to light up the pathway to the bedroom.
The last item in this blog involves securing the drain line. I run the Cycler drain line to the shower in our Master Bath. It is common to tape down the drain line but cumbersome to do so. You have to get down on hands and knees to do this I’ve come up with a better way (for me) to secure the end of the drain line. My wife sacrificed a plastic bowl from the kitchen which I modified by drilling a 1/4 ” hole in the side about 1″ down from the edge. I then used scissors to cut out a “V”-shape to the drilled hole. I slip the “Yellow” plastic drain line bitter end into the V and thence to the hole to secure it. Then using the line, I just swing it into position covering the drain under the bowl face downward and I’m done. In the morning as part of cleanup I pull the bowl out of the shower, remove and cap off the line, rinse out the bowl and place it in the shower on the enclosed bench, and I’m done. Pictures follow.
And the next blog will be about?
Leave a Reply